DescriptionRRS belt tensioner pulley socketOften the bearing is worn out of the roller on the belt tensioner, this can cause annoying noises and it must then be replaced.To remove the idler pulley from the belt tensioner, many of the tensioners on the ZZ motors require a special wrench that is standard in tool sets. This cap is for this, it is specific for the bolt of the belt tensioner (version with visible bolt) For the tensioners where the pulley has a plastic cap over the bolt, this is not necessary. Under the hood is a standard Torx bolt.This cap is not necessary for removing the entire tensioner, purely if you want to replace the roller on the tensioner yourself.Sizing: 14mm 1/2″ (large ratchet) 17mm wrench
